These 85% AR-15 Lower receivers start as 7075-T6 forgings from the lead forge in the USA and are fully machined to mil-spec tolerances.These are Raw unfinished or anodized with a mil-spec hard coat anodized finish.This is a not an FFL item, and can be shipped directly to you.
- 7075 USA Made Forged Aluminum
These are machined/finished to the maximum allowable amount without becoming a firearm. These differ from other 80%'s on the market because these 80%'s are newset to market and have the rear upper lug area machined out.
Machined with the following:
- Magazine Well (cut using an EDM Wire Cutter)
- Front Pivot Pin Holes
- Rear Take-Down Pin Hole
- Threaded Receiver Extension
- Front Pivot Detent Hole
- Rear Take-Down Detent Hole
- Buffer Detent Hole
- Fully-Machined Bolt Catch
- Fully-Machined Magazine Release
- Trigger Guard Holes
- Upper Receiver Rear Lug Pocket
- NO FFL NEEDED FOR PURCHASE. This item can be shipped directly to your house
As determined by the Firearms Technology Branch of the ATF, this lower receiver is not classified as a "firearm". The ATF examination confirmed that the forging has been partially machined, but has no machining of any kind performed in the area of the trigger/hammer recess, and therefore is not classified as a "firearm" and may be sold as such under applicable federal and state laws. These are top of the line, great for a home build or cool paper weight.
What do you need to do to complete one of these into a working firearm? Complete the fire control pocket and drill three holes in the side of the fire control area. (we even have jigs available to help you do complete our 80%).
These are available as RAW unfinished at this time and supply is limited, so please order accordingly, thanks!